Publicité
5.3
Placing the product in the tank AR-SM
MECHANICAL STRESS CAUSED BY EDGES
•
Do not pull the product through the manhole.
•
Du not pull the product over the bottom or the tank bottom.
•
Make sure the tank has been lined with an approved intermediate layer.
Failure to follow these instructions can result in equipment damage.
Mounting
NOTICE
3. Remove the product in the
plastic sack from the car-
ton and place it directly into
the tank.
- Do not place the product
on the floor in between to
avoid damage.
4. Place the inner lining in the
tank in the plastic sack.
- Do not drop the product
into the tank
5. Remove the product from
the plastic sack.
- Do not pull on the
feed-through line, as this
may cause it to leak.
6. Unreel the product on the
tank bottom in such a way
that the manhole neck of
the product is immediately
below the manhole of the
tank.
AR-S / AR-SM
EN
9
Publicité
