OPERATING INSTRUCTIONS
TEMPERATURE CONTROL
1. Power Button: Press the power button once to
turn the appliance on. Press and hold the power
button for 3 seconds to turn the appliance off.
2. Light Button
3. Power Light: Indicator light illuminates to signify
that cooling mode is currently in operation.
4. °C / °F: Indicator lights signify which
temperature scale is being displayed.
5. Temperature Display: Shows the set
temperature.
6. Up and Down Buttons: Used to increase or
decrease the set temperature in 1° increments.
3
4
°C
°F
1
5
2
INTERIOR LIGHT
The interior light will default to turning on and off
when the door is opened or closed.
Press the light button once to turn the light off while
the door is open. The light will resume default
functioning when the door is closed.
There are three light mode settings:
• L1: The light will turn on and off when the
door is opened and closed.
• L2: The light will remain on indefinitely at
100% illumination.
• L3: The light will remain on for 60 minutes at
100% illumination and then turn off.
• L4: The light will remain on for 60 minutes at
50% illumination and then turn off.
To change the light mode, press and hold the light
button for 3 seconds until L1 flashes on the display.
Press the up or down button to change between
modes. The display will flash the chose mode 3
times to confirm.
STORAGE INSTRUCTIONS
The maximum capacity of this appliance is 27 (750
ml) wine bottles and 64 (355 ml) cans.
Wine Compartment (Right): It will be necessary
to position the bottles alternately on the upper
six shelves. This will allow for the storage of four
750ml bottles on each of the top six shelves and
three bottles on the bottom shelf for a total storage
capacity of 27 wine bottles.
6
Beverage Compartment (Left): The top 3 shelves
can hold 18 355ml cans per shelf. 10 cans can be
stored in the bottom for a total storage capacity of
64 beverage cans.
5
OPERATING INSTRUCTIONS
FUNCTION INSTRUCTION
The default temperature setting is 54°F (12°C). The
default temperature scale is °F.
To switch the display between °F and °C, press and
hold the up and down buttons at the same time for
approximately 3-5 seconds.
Beverage Zone (left side): The temperature can be
set as low as 37°F (3°C) or as high as 64°F (18°C).
Wine Zone (right side): The temperature can be set
as low as 41°F (5°C) or as high as 64°F (18°C).
Actual temperature inside the appliance can vary
based on ambient temperature, how often the door
is opened and how many warm beverages have
recently been added to the appliance.
Each depression of the up and down buttons will
adjust the temperature in 1° increments.
Temperature Memory
If the appliance loses power, the control panel
will remember the set temperature. Once power
is restored, the appliance will return to normal
functioning automatically.
Demo Mode
This mode can show what the appliance will look
like when in use without engaging the compressor.
The light will function normally, the fan will run on
low speed and all alarms will be disabled.
To engage demo mode, press and hold the light
button and the down button at the same time for 10
seconds. The display will flash "dE" and "on" five
times to confirm.
To disengage demo mode, press and hold the light
button and the down button at the same time for 10
seconds. The display will flash "dE" and "of" five
times to confirm.
ALARM INSTRUCTION
Door Ajar Alarm
If the door is not closed completely for 5 minutes,
an alarm will sound. Close the door to silence the
alarm.
If the door is closed and the alarm continues to
sound, check that the actuator at the bottom of
the door is making contact with the switch on the
appliance.
If the door alarm sounds when loading the
appliance, it can be silenced by pressing the power
button once.
Temperature Alarm
If the inner cabinet temperature is higher than 73°F
(23°C) for one hour, the error code "HI" will show
on the display panel and an alarm will sound.
If the inner cabinet temperature is lower than 32°F
(0°C) the error code "LO" will show on the display
panel and an alarm will sound.
If the inner cabinet temperature remains at 32°F
(0°C) for more than 30 minutes, the error code
"CL" will show on the display panel and an alarm
will sound. The appliance will stop functioning to
prevent the contents from freezing.
IMPORTANT
Ensure that the door is fully closed when the
appliance is in operation. Failure to fully close
the door can lead to excessive condensation
and potential water damage to flooring under
the appliance. Danby will not be responsible for
damages from misuse.
6