Publicité
Operation
WARNING
Before every use, make sure that:
•
•
•
•
•
•
•
WARNING
•
•
CAUTION
After restarting the device, there is a 3-minute delay before the compressor
starts working.
CAUTION
The device only cools if it has power and is switched on.
When the device is connected to the power supply, the on/off indication light
(Figure 6, pos. 7) is on.
Turn on
1.
Press
for 5 seconds.
2.
The display will turn on.
Set the temperature
CAUTION
The temperature of the small box must be the same or lower than that of the
large box.
1.
Press
or
2.
The display shows the set temperature and flashes for 5 seconds.
3.
The temperature is set.
The 'L' or the 'R' is displayed.
4.
5.
The display shows the current temperature inside the device.
When the desired temperature is reached, the 'L' or 'R' disappears.
6.
you operate the device with dry hands;
the device, power cable and plug are clean and dry;
the device is not exposed to any liquids;
the device is not damaged;
the device is not covered or blocked;
the device is placed on a flat, stable and steady surface.
the device is not placed near heat sources and open fires.
Do not use product in combination with a battery and quick charger.
Disconnect or switch off the device when you turn off the engine from the
vehicle. Otherwise you may discharge the vehicle battery.
to set the desired temperature with the desired box ('L' or 'R').
35
Publicité
