Publicité
Plug power cord into an outlet at the correct voltage.
Plug power cord directly into unit. Be sure clipper is swit-
ched OFF when charging.
For corded operation, connect to receptacle on the bottom
of the unit. If your battery is completely run down, allow the
unit to charge for 3-5 minute (switched OFF) before using as
a corded unit.
If the cord is left attached to the unit when not in use, the
cord will automatically charge the unit.
when left in the OFF position.
MAINTENANCE AND CLEANING
Unplug the product when you do not intend to use it for
an extended period of time to prolong its service life.
Allow the device to cool down prior to storage. Use the
cleaning brush (8) to remove dust from the internal parts.
Apply a drop of oil (7) on one of the edges of the blades
for their maintenance and turn on the device for a few
seconds to distribute it. This should be done when you
notice a certain amount of difficulty during the trimming
operation.
Ensure that the device is unplugged prior to cleaning it.
This device may only be cleaned with a damp cloth, and
chemical products must never be used for the same.
23
Publicité
