Publicité
- The appliance cannot be handled before it cools down.
-Do not place the appliance up against walls, furniture, curtains, etc.
This IPX1 device has been designed in such a way that it can be used in any room, in-
cluding those where there is a risk of splashing from above, such as the bathroom, kit-
chen, etc. However, both the electrical installation of the product and the way in which
it is used must comply with the safety regulations in force in your country.
If the appliance is placed in a bathroom, never place it above a bathtub. Keep it at least
60cm away from the bathtub to avoid possible splashing, as shown in the figure:
B&B TRENDS SL accepts no liability for any damage that may be caused to people,
animals or objects owing to failure to observe this warning correctly.
INSTRUCTIONS OF USE
1. Connect the mains plug to a mains socket with the correct voltage.
2. Turn on the main power switch at the back of the heater to the I position. The heater
will enter standby mode. (The power indicator light will flash and will only turn off when
the heater is turned on.) Check the heater's rating plate for the correct voltage.
3. Press the ON/STAND-BY
touch button to turn on the heater, the fan mode icon
and anti-frost icon
will be displayed along with the room temperature. The anti-frost
function maintains the room temperature at 7°C. If the temperature in the room is be-
low 7°C, the appliance will automatically turn the heater on to high power
to warm
up the room. If the temperature is above 7°C the appliance will automatically select fan
mode
to cool the room.
4. Press
button repeatedly to toggle between fan mode
, heater low power
and heater high power
.
5. Press
to increase/decrease the desired room temperature(15-35°C). After 5 se-
conds of setting the temperature, the heater will display the room temperature. The
heater will turn on/off when the room temperature is lower/higher than the present
temperature.
6. Press
to enter timer mode. The timer icon
will display and the hour digit will
flash. Press
to set a time period after which the heater will turn off. After 5 seconds
of setting the timer, the heater will display the room temperature.
7. Press
to enter ECO mode. The eco icon
will be displayed. The default tem-
perature is 23°C. The appliance will compare your preset target temperature with the
current room temperature and will select the most appropriate heating level to maintain
20
Publicité
