Publicité
ELECTRICAL PRUNING SHEAR
14.1 CUTTING CONTROL MODE
The KP400 electric pruning shears has two cutting control modes:
•
Non-progressive cutting control
•
Progressive cutting control
NON-PROGRESSIVE CUTTING CONTROL
When the pruning shear is turned on, the non-progressive cutting control is
predetermined, that is, when the trigger is actuated the blade performs the
cutting action, and when the trigger is released the blade opens.
PROGRESSIVE CUTTING CONTROL
To change the control mode, you must hold the trigger for 2 seconds until you
hear an audible warning (a beep), which indicates that you have changed from
normal cut control mode to progressive cut control mode.
In the progressive cutting control the blade moves according to the depth of
the trigger drive, that is, if the trigger is activated halfway, the blade moves
progressively halfway through its opening.
14.2 OPENING CHANGE (ONLY IN PROGRESSIVE MODE)
The KP400 shears incorporates a system of change of opening with memory. It
means that we can adjust the opening of the head in function of the diameter
of cut wished.
In the progressive cutting control mode, the cutting diameter can be adjusted
and a smaller cutting diameter can be set, for which the position of the
blade at the desired cutting diameter must be maintained for 1 second and
an audible warning will sound (a beep) indicating that the selected cut-off
opening diameter has been memorized.
To return to maximum opening, we keep the trigger pressed until two audible
beeps are heard (two beeps), which indicates that the opening memory has
been removed.
72
www.gruposanz.es
Publicité
