Home Decorators Collection 52-WWDIV Guide D'utilisation Et D'entretien page 8

Assembly - Close-To-Ceiling Mount
1
Close-to-Ceiling Mounting
□
Remove the canopy ring (FF) from the canopy (C) by turning the
ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (JJ) located in the "L shaped"
slots.
□
Remove and save the two canopy screws (II) in the round
holes. This will enable you to remove the mounting bracket (A).
□
Remove the decorative canopy bottom cover (L) from the
canppy (C) by depressing the three studs.
2
Routing the wires
□
Remove three of the six screws and lock washers (KK)(every
other one) securing the motor collar to the top of the fan-motor
assembly (E).
□
Route the wires exiting the top of the fan-motor assembly
(E) through the rubber gasket (CC) aligning the holes in the
rubber gasket (CC) with the three screw holes in the fan-motor
assembly (E).
□
Route the wires exiting the top of the fan-motor assembly (E)
through the canopy ring (FF), and the canopy (C) (make sure the
slot openings for the canopy ring and canopy are on top). Place
the canopy (C) over the collar (M) at the top of the motor (E).
□
Align the mounting holes in the canopy (C) with the screw holes
in the motor (E) and fasten using the three screws and lock
washers (KK) (removed previously). Tighten the mounting screws
securely.
3
Attaching the fan to the electrical box
WARNING: To reduce the risk of fire, electric shock
or personal injury, mount to outlet box marked
"acceptable for fan support of 35lbs. (15.9 Kg) or
less" using the screws provided with the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Install the ceiling mounting bracket on the outlet box by sliding
the mounting bracket (A) over the two screws (UU) provided with
the outlet box. If necessary, use leveling washers (not included)
between the mounting bracket (A) and the outlet box. Note that the
flat side of the mounting bracket (A) is toward the outlet box. When
using close-to-ceiling mounting, it is important that the mounting
bracket be level.
□
Securely tighten the two mounting screws (UU).
JJ
KK
KK
KK
KK
M
FF
M
FF
UU
8
A
II
C
L
FF
C
C
CC
CC
E
E
C
CC
C
CC
E
E
UU
A