Publicité
Safety notes
• The light may only be used when mounted inside
and outside.
• The user of the device must have read and under-
stood these operating instructions prior to its first
use in order to safely implement this device.
• Always keep the operating instructions within
reach.
• If you sell or pass on the device, you must also
pass on these operating instructions.
• The device must only be used when it functions
properly. If the device or part of the device is
defective, have it repaired by a specialist.
• When drilling into wall, ceilings or floors pay atten-
tion to cables as well as gas and water pipes.
• The electrical connection may only be carried out
by an appropriately qualified professional.
• Only use bulbs permitted by the manufacturer.
The maximum bulb performance may not be
exceeded (► Technical data – p. 12).
• Only use connection clamps permitted by the
manufacturer.
Assembly
Note: The actual appearance of your
product may differ from the illustrations.
DANGER! Danger to life due to electri-
cal shock! The electrical connection may
only be carried out by an appropriately
qualified professional.
Before installation, switch off the power to
the electrical network (switch off at the
main switch/fuse box).
► Assembly – p. 2
– Screw the individual pieces together securely.
– Unscrew the connection housing.
– Feed the mains cable through the cable seal.
– Connect the mains cable.
– Screw the connection housing back together
again.
– Screw the foot of the lamp securely to the floor.
Fault/malfunction
The lamp does not light up
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
– Screw the bulb into place.
Exterior light
– Screw the cover on tight.
Changing the bulb
Cleaning
– Wipe down the device with a dry or damp cloth.
Storage and transport
Storing
– Store the device and any accessories in a dry,
– In case of longer periods without operation, pro-
Transport
– Use the original packaging to ship whenever pos-
Troubleshooting
If something stops working...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Cause
No mains voltage?
Light source defective?
Luminaire switched on via switch?
Switch defective?
Connection cable defective?
Incorrect connection?
CAUTION! Danger of being burnt! The
light bulb gets hot when used! Before
changing the bulb, allow it to cool first.
NOTICE! Risk of damage to the
device! Do not use any sharp or abrasive
objects, or aggressive cleaning agents.
Do not use cleaning solutions.
well-ventilated place.
tect the device and its accessories against soiling
and corrosion.
sible.
DANGER! Danger to life and limb!
Improper repairs can result in the product
functioning unsafely. This endangers
yourself and your environment.
DANGER! Risk of fatal injury due to
electric shock! All work to eliminate pos-
sible faults should be carried out with the
fuse switched off. All work should be car-
ried out by a qualified electrician.
Remedy
Check fuse. Contact a specialist.
Check light source, replace if neces-
sary if possible
Check switch position
Contact a specialist.
Contact a specialist.
Switch off the fuse and check the
connection according to the wiring
diagram. Contact a specialist.
GB
11
Publicité
