Publicité
3 Installation instructions
3.1 Mounting the heater
Wall mounting
NOTICE
: Material damages!
Use screws that are suitable for the wall
material and the weight of the heater.
After the installation position of the water heater
n
is determined, drill two holes with a spacing of
2.44 inch and a diameter of Φ0.394 inch in the
horizontal direction of the wall according to the
size as shown in the following figure, and the
hole depth shall not be less than 2.76 inch. Insert
two plastic expansion tubes into the hole, and fix
the water heater bracket with fastening screws.
Install the wall hole
Before hanging the water heater, carefully align
n
the two hanging holes on the back of the unit
with the two hooks on the support bracket. Once
they are matched up, firmly pull down to secure
the holes onto the hooks.
Water Heater
CAUTION
The appliance must be hung securely to
prevent personal injury and property
damage from falling.
Floor mounting
Heater can sit on floor.
n
0.394
2.44
Hanging Bracket
(on the water heater)
Plastic Shell
Water Heater Bracket
Plastic Expansion
Tube
Fastening Screw
Wall
3.2 Pipe connections
Connect the cold water inlet pipe to the inlet
n
tapping (marked with a blue ring).
Ensure a isolation valve is installed on the cold
n
water supply to the water heater.
Connect the hot water outlet pipe to the outlet
n
tapping (marked with a red ring).
CAUTION
To reduce the risk of excessive pressures and
temperatures in this water heater:
Install the supplied temperature and
n
pressure protective equipment required by
local codes but not less than a combination
temperature and pressure relief valve
certified by a nationally recognized testing
laboratory that maintains periodic
inspection of production of listed equipment
or materials, as meeting the requirements
for Relief Valves and Automatic Gas Shut-off
Devices for Hot Water Supply Systems,
ANSIZ21.22.
The supplied temperature and pressure relief valve
is marked with a maximum set pressure (150 psi)
that does not exceed the marked maximum
working pressure of the water heater.
Install the Temperature and pressure relief valve
n
in the opening provided and marked for this
purpose in the water heater.
Orient it or provide tubing so that any discharge
n
from the valve will exit within 6 inches above, or
at any distance below, the structural floor, and
cannot contact any live electrical part. The
discharge opening must not be blocked or
reduced in size under any circumstances.
NOTICE
Wrap the Teflon tape around the threaded
opening of the pressure relief valve at least
15 times (approximately 47.2" (120 cm) in
length) in order to prevent water leakage.
Wrap at least
15 times
Installation instructions
Teflon tape
07
Publicité
