Publicité
1. Put the protection guard (5) on the machine, as
shown on fi gure C.
2. Mount the protection guard (5) by tightening
the two screws.
Inserting the battery into the machine (Fig. A, D)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (2) into the base of the machine
as shown in Fig. D.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. A, D)
1. Push the battery unlock button (3).
2. Pull the battery out of the machine like shown
in Fig. D.
Checking the battery charging status (Fig. E)
• To check the battery charge status, push the
button (9) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more charge
the battery has left.
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the charger (Fig. E)
1. Take the battery (2) from the machine.
2. Turn the battery (2) to upside down position and
slide it onto the charger (11) as shown in Fig. E.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators (12) on
the charger (11) will lighten up and show the
charger status.
The charger has 2 LED indicators (12) which indicate
the status of the charging process:
WWW.VONROC.COM
Red LED Status
Green LED status
Off
Off
Off
On
On
Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the charger
plug from the outlet and remove the battery from
the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
4. OPERATION
Before using, always visually inspect to see
that the blades, blade bolts and cutter
assembly are not worn or damaged.
You may not use the hedge trimmer without
the protection guard.
Always use both hands to hold the hedge
trimmer and keep it away from your own
body.
Using your hedge trimmer
• For your own safety and for best results read
the following user advice and do not use this
product for anything other than its intended
purpose.
• This hedge trimmer is made for cutting hedges
and bushes. All other use that is not specifi cally
allowed in this manual mat lead to manage to
the hedge trimmer or injury to the user.
Switching on and off (Fig. A)
• To switch the trimmer on, press the safety switch
(7) and the start switch (1) at the same time.
EN
Charger status
No power
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
fi nished
Battery charging in
progress
9
Publicité
