Important Preparation Suggestions - Blomberg CTE 30400 Instructions D'installation

Figure 3. Cutout dimensions and requirements
CUTOUT
A
WIDTH
28-11/16"
(72.9 cm)
30"
28 15/16"
(76.2cm)
(73.5 cm)
34-1/16"
(86,5 cm)
36"
34-5/16"
(91.4 cm)
(87.2 cm)
IMPORTANT
Under the cooktop it is necessary to install a partition,
spaced at least 15 mm. from the bottom of the
appliance as shown in figure 3.

Important Preparation Suggestions

1. Chamfer all exposed edges of decorative laminate
to prevent damage from chipping.
2. Radius corners of cutout and file to Insure
smooth edges and prevent corner cracking.
Recommend 1/4"or 3/8"diameter drill In each
corner.
3. Rough edges, inside corners which have not been
rounded and forced fits can contribute to cracking
of the countertop laminate.
B C
19-1/4"
(49.0 cm)
30"
19-�/�"
(76.2 cm) min
(49.� cm)
19-1/4"
(49.0 cm)
36"
19-�/�"
(91.4 cm) min
(49.� cm)
* NOTE
24" (61 cm) min. clearance if bottom of wood or metal cabinets is
protected by not less than 1/4" (0.6 cm) flame retardant millboard
covered with no less than No. 28 MSG sheet steel 0.015" (0.04 cm)
stainless steel, or 0.024" (0.06 cm) aluminum or 0.020" (0.05cm) copper.
30"(76.2 cm) min. clearance between top of cooking platform and bottom
of unprotected wood or metal cabinet
D E
18" (45.7 cm) 30" (76.2 cm)
min min.
(see note*)
Height from
Clearance from
countertop to
nearest countertop to
cabinet on unprotected
either side of overhead
unit surface
This cooktop has been designed with wide
tolerances of cut-out to cover possible
replacement with other brands. We recommend to
that you consider the minimum dimension of cut-
out size In the case of new Installation.
Some cut out sizes for possible replacements:
Inches
Dim.
30"
28-15/16" x 19-�/�"
x
36"
34-5/16" x 19-�/�"
x
Installation Manual
ENGLISH
F G
2" (5 cm) min
13" (33 cm)
Clearance from
Depth of
cutout to side
unprotected
wall on the left
overhead
and right of the
cabinets
unit
cm
73,5 x 49,�
87,2 x 49,�
5