Publicité
TROUBLE SHOOTING
WARNING: Read instruction manual first! Remove plug from power source before making
adjustments or assembling accessories.
Problem
Motor will not start.
Unit does not reach high
pressure.
Output pressure varies
high and low.
Motor buzzes but fails to
run.
No water.
Possible Cause
1. On/Off switch is in the "OFF"
(O) position.
2. Power cord is not plugged in.
3.
Electrical outlet does not
supply adequate power.
4.
Tripped pressure washer
circuit breaker.
5.
Power switch is ON however
gun trigger is not squeezed ON.
1.
Water supply is restricted.
2.
Not enough water supply.
3.
Pressure Tip has not been
installed on wand assembly
4.
Water intake filter is clogged.
1.
Not enough inlet water
supply.
2.
Pump is sucking air.
3.
Water inlet filter clogged.
4.
Supply voltage below
minimum.
5.
Calcified gun, hose or power
spray tip.
1.
Supply voltage below
minimum.
2.
System has residual pressure.
3.
Voltage loss due to extension
cord.
4.
Pressure washer not used for
long periods.
5.
Residual friction among
components. Unit might hum.
1.Water supply is OFF.
2.Kink in the garden hose.
1.
Set switch to the "ON" ( | ) position.
2.
Plug in power cord.
3.
Try a different outlet.
4.
Allow to cool, and restart unit.
5.
With power switch ON push in on the
gun
trigger which will engage the AUTO ON
switch.
1.
Check garden hose for kinks, leaks and
blockage.
2.
Open water source fully.
3.
Add desired pressure tip to end of wand.
4.
Remove filter and rinse in warm water.
1.
Turn water on fully. Check garden hose
for kinks, leaks or blockage.
2.
Check that hoses and fittings are airtight.
Turn "OFF" machine, and purge pump by
squeezing trigger gun until a steady flow of
water emerge through the spray tip.
3.
Remove filter and rinse in warm water.
4.
Verify that only the pressure washer is
running on this circuit.
5.
Run distilled vinegar through detergent
tank.
1.Verify that only the pressure washer is
running on this circuit.
2.Turn unit "OFF", squeeze trigger on
spray wand to release pressure, then turn
unit "ON".
3.Unplug any extension cords attached and
plug the unit directly into the outlet.
4.Call customer service.
5.Disconnect water supply and power ON
for 2 to 3 seconds, repeat couple times or
until the motor starts.
1.Turn ON water supply.
2. Remove kink in garden hose.
20
Possible Solution
Publicité
