Safety Precautions; Explanation Of Symbols; Operating Instructions; Inserting The Cable Holder - EAL 16628 Manuel De L'opérateur

• When pulling the mains cable out of the socket, only hold the plug.
• Never expose the charger to the vicinity of fire, heat and extensive temperatures over +40°C.
• Store these instructions carefully and, if necessary, pass them on to other users.

5.EXPLANATION OF SYMBOLS

Corresponds to EC
directives
Insulated housing
(protection class II).
Read the operating
instructions

6. OPERATING INSTRUCTIONS

Before using the device make sure that you have read the operating instructions for the battery and the
vehicle and you have understood all of the safety precautions.

6.2 INSERTING THE CABLE HOLDER

Insert the cable holder into the mounts (Position 8 in the overview) on the rear of the charger so that the openings
of the vertically aligned cable holders face away from each other.
Labelled electrical
product may not be
disposed of in the
household waste
Fuse,
here: Slow-burning,
1.6A
Corresponds to the
requirements of § 21
of the German
Product Safety Law
(Produktsicherheitsg
esetz)
1 Carry handle
2 Switch for selecting charging mode normal/fast
3 Switch for selecting battery type normal/gel
4 Control lamp – Green - Fully charged
5 Control lamp – Yellow - Charging
6 Control lamp – Green - Operating
7Control lamp – Red - Pole callipers connected incorrectly
Figure 1: View of front
1 Carry handle
8 Mounts for cable holder
9 Type plate
10 Mains connection cable
11 Charging cable
Figure 2: View of rear
Devices with this
symbol may only be
operated in the
house (dry
environment)
Recommended
battery capacity
Protection class
IP65 Spray water
protected
9