WAHLBACH Elex 8,5 Instructions De Montage Et D'utilisation page 17

Make sure the pressure of your water supply system supersedes the 0,5bar (0,05MPa).
The electronically-regulated continuous-flow water heater with automatic performance adjust-
ment keeps the outflow temperature constant. This takes place irrespective of the feed tem-
perature, up to the performance limit. The hot water outflow temperature is infinitely variable.
User instructions:
• The appliance shall have a control panel
• with a display that is able to continuously monitor the level you have set
• there are also push-buttons to switch the appliance on and off, and the
arrows can be used to increase or decrease the temperature levels:
Level T emperature
1 40 °C
2 41 °C
3 42 °C
4 43 °C
5 44 °C
6 45 °C
7 46 °C
8 47 °C
9 48 °C
10 50 °C
11 55 °C
12 60 °C
Temperature and flow rate
Rating power
8,5 kW
Note: Parameters in the above diagram are drawn under the following condition:
Voltage Supply: 230V /50Hz
These are typical values. Depending on the circumstances,
there may be slight differences between the declared values
and actual measured values.
It may happen that the declared values are not achieved
because the flow rate is too high for the nominal power
rating of the device.
On delivery the device is set to level 3.
Flow rate (Δt)
2.5 L/min
+45 °C
DE GB NL FR
3 L/min 3.5 L/min
+40 °C +34 °C
17