Technics SL-G700M2 Manuel D'utilisation page 14

Network settings
Basic
Wired LAN connection
Broadband router, etc.
1 Disconnect the AC power supply cord.
2 Connect this unit to a broadband
router, etc. using a LAN cable.
3 Connect the AC power supply cord to
this unit. ( 12)
4 Press [NWP
unit on.
• When the connection is established, "
displayed.
5 Press [>INPUT<] to select "Chromecast
built-in".
(Using Google Home app)
6 Open the Google Home app and
follow the on-screen instructions to
set up a connection. ( 16)
(Using Apple Home app)
6 Open Apple Home app and follow
the on-screen instructions to set up a
connection. ( 16)
Note
• While the AC power supply cord is
disconnected, the LAN cable must be
connected or disconnected.
• Use category 7 or above straight LAN cables
(STP) when connecting to peripheral devices.
• Inserting any cable other than a LAN cable in
the LAN port can damage the unit.
• When a LAN cable is connected, the Wi-Fi
function may be disabled.
Wireless LAN connection
■
Preparation
Disconnect the AC power supply cord.
Disconnect the LAN cable.
Place this unit as close to the wireless router as
possible.
14
(14)
(Continued)
LAN cable
(not supplied)
]/[CD ] to turn this
Point up the antenna on the rear of this unit as
shown in the figure.
Connect the AC power supply cord to this unit.
( 12)
Note
• The setting will be cancelled after the set time
limit. In that case, try the setting again.
• To cancel this setting in the middle, press [
turn the unit to standby mode.
• When the connection is established, "
displayed. ( 16)
Network setting for the first time using
app
" is
1 Press [NWP
unit on.
• "Wi-Fi Setup" is displayed.
2 Press [ ], [ ] to select "Yes" and press
[OK].
• "Setting" is displayed.
(Using Google Home app)
3 Open the Google Home app and
follow the on-screen instructions to
set up a connection. ( 16)
(Using Apple Home app)
3 Open Apple Home app and follow
the on-screen instructions to set up a
connection. ( 16)
Note
• This unit will be displayed as "Technics-SL-
G700M2-
****
(" " stands for characters unique to each
****
set.)
• You can check your network information (SSID,
MAC address and IP address) from the Google
Home app or "Technics Audio Center" app.
• Some items on the Google Home app are
irrelevant to this unit.
• When this unit is switched to standby mode and
turned on before the Wi-Fi setting is complete,
"Wi-Fi Setup" is displayed. Complete the Wi-Fi
setting or set "Wi-Fi Menu" to "Off" to turn off
the display.
]/[CD ] to turn this
" if the device name is not set.
] or
" is