Technics SL-G700M2 Manuel D'utilisation page 12

Connections
Basic
Connecting to an amplifier
XLR cable
Analog audio
cable (supplied)
Pre-amplifier with
unbalanced input
terminals
(AV receiver, control amplifier, etc.)
: We recommend using cables with a length of
*
3 m (10 ft) or less.
• For details, refer to the operating instructions of
the connected device.
• Do not use any other analog audio cables
except the supplied one.
Connecting to a digital audio output
device
Optical digital
audio cable
(not supplied)
Digital audio output device
12
(12)
*
(not supplied)
Pre-amplifier with
balanced input
terminals
Amplifier
Coaxial digital
cable
(not supplied)
• Audio signal of Super Audio CD and Super
Audio CD layer of Hybrid Super Audio CD
cannot be output from the digital audio output
terminal of this unit. Connect the device to the
analog audio output terminal.
• When enjoying video contents with this
function, the video and audio output may not
be synchronized.
• For details, refer to the operating instructions of
the connected device.
AC power supply cord connection
Connect only after all other connections are
completed.
AC power supply cord
To a household
AC outlet
Insert the AC power supply cord up
to a point just before the round hole.
• Use only the supplied AC power supply cord.
• Insert the plugs of the cables to be connected
all the way in.
• Do not bend cables at sharp angles.
• Wireless LAN (Wi-Fi ) setting may start when
®
this unit is turned on. If you stop the Wi-Fi
setting, select "No" in "Wi-Fi Setup" screen.
Select "Yes" to keep the Wi-Fi setting. ( 14)
• Press [NWP] first to operate this unit.
Note
• This unit consumes a small amount of AC power
( 20) even when the unit is in standby mode.
Remove the plug from the main electrical outlet
if you will not be using the unit for an extended
period of time. Place the unit so the plug can be
easily removed.
(supplied)