mitzi JAIMEE HL539401 Instructions D'installation

HUDSON VALLEY LIGHTING
5
4
3
2
1
ITEM DESCRIPTION
1 MARBLE BASE
2 FIXTURE ASSEMBLY
3 SHADE
4 BULB
5 SOCKET RING
www.hvlgroup.com
JAIMEE
HL539401
·
INSTALLATION INSTRUCTIONS
·
·
·
·
·
FIXTURE INSTALLATION
1.
2.
3.
4.
PART NUMBER
MIS-HL539401
FAS-HL539401
SHD-HL539401
NOT INCLUDED
RNG-HL539401
DISCONNECT POWER BEFORE RE-LAMPING OR WIRING THE FIXTURE. READ ALL INSTRUCTIONS
COMPLETELY BEFORE STARTING INSTALLATION.
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH
ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES. THE INSTALLATION
AND MAINTENANCE OF THIS UNIT SHOULD BE COMPLETED BY A LICENSED ELECTRICIAN OR
CERTIFIED FACTORY TRAINED TECHNICIAN.
CALIFORNIA PROP 65: THIS LIGHTING FIXTURE CONTAINS CHEMICALS KNOWN TO THE STATE OF
CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS, AND/OR OTHER REPRODUCTIVE HARM. WASH
HANDS AFTER USE.
REMOVE THE FIXTURE, PARTS AND PARTS BAG(S) FROM THE CARTON. BEFORE DISCARDING
THE CARTON, DOUBLE CHECK TO MAKE CERTAIN THAT ALL PARTS ARE FOUND. INSPECT THE
FIXTURE PRIOR TO INSTALLATION FOR ANY DAMAGE TO THE FIXTURE.
DIMMING: THE FIXTURE CAN BE CONTROLLED BY A WALL DIMMING DEVICE. ONLY USE
TRIAC/ELECTRONIC DIMMER. MAKE SURE THE CARTON IS MARKED FOR USE WITH LED
COMPACT FLUORESCENT-INCANDESCENT LIGHT SOURCE ONLY. THESE CAN BE PROVIDED BY
YOUR LOCAL ELECTRICAL DISTRIBUTOR, HOME CENTER, OR HARDWARE STORE.
PLEASE CLEAN WITH A SOFT, DRY CLOTH ONLY! DO NOT USE CLEANSERS
Attached the FIXTURE ASSEMBLY (1) onto the BASE (1).
Carefully remove the protective covering over on the SHADE (3), place the SHADE (3) on the FIXTURE
ASSEMBLY (1) and secure with the SOCKET RING (5).
Install the BULB (4) into the socket.THIS FIXTURE IS RATED FOR 60 WATT LAMP. DO NOT EXCEED THE
RECOMMENDED WATTAGE!
Plug the cord into the wall outlet. Turn the switch on the cord.
Contact us at CustomerService@hvlgroup.com
WARNING/CAUTION
Questions? We're here to help!