mitzi LINDSAY HL291101 Notice D'assemblage

ASSEMBLY AND MOUNTING INSTRUCTIONS
GENERAL
•
WARNING-ALWAYS UNPLUG THE LAMP TO CUT ELECTRIC
POWER OFF BEFORE INSTALLING, CLEANING, OR OTHER
MAINTENANCE.
•
FAILURE TO INSTALL FIXTURE CORRECTLY COULD RESULT IN
SERIOUS INJURY OR DEATH
INSTALLATION
STEP 1.
Remove the table lamp and parts from the Carton.
STEP 2. Lift the glass onto the glass fitter then secure it with the
metal cup and socket ring.
STEP 3. Install the Lamp. This fixture is rated for 60 watt type A
lamp. DO NOT EXCEED RECOMMENDED WATTAGE
STEP 4. Attach the mounting plate to the wall, mark the targets
on the wall from the set holes. Remove the mounting
CLEANING
Please clean with a soft, dry cloth ONLY! Do not use cleaning products
ASSEMBLY AND MOUNTING DIAGRAM
www.hudsonvalleylighting.com/mitzi| #mymitzi
HL291101 LINDSAY TABLE LAMP
•
READ ALL INSTRUCTIONS BEFORE STARTING INSTALLATION.
•
BEFORE DISCARDING THE CARTON DOUBLE CHECK THE
PACKAGING TO MAKE SURE ALL PARTS HAVE BEEN FOUND.
plate.
STEP 5. Drill the holes and thread anchors into the holes and
thread the wall screws into the anchors.
STEP 6. Hanging the fixture on the wall.
STEP 7. Plug cord into a qualified socket of properly rated
voltage.
STEP 8. On/Off switch installed on cord.