Publicité
For installation instructions refer to
figures at pag. 2/9
ELECTRICAL CONNECTION
The mains power supply must correspond
to the rating indicated on the plate situated
inside the hood. If provided with a plug
connect the hood to a socket in compliance
with current regulations and positioned in
an accessible area, after installation. If it not
fitted with a plug (direct mains connection)
or if the plug is not located in an accessible
area, after installation, apply a double pole
switch in accordance with standards which
assures the complete disconnection of the
mains under conditions relating to over-cur-
rent category III, in accordance with installa-
tion instructions.
Warning! Before re-connecting the hood
circuit to the mains supply and checking
the efficient function, always check that the
mains cable is correctly assembled.
Warning! The hood is provided with a
special power cable; if the cable is damaged,
request a new one from Technical Service.
CONTROL PANEL
TYPE "A"
-
Pilot light
-
Fan-off
-
First speed (minimum)
-
Second speed (medium)
Third speed (maximum)
-
-
Light ON/OFF
en
es
TYPE "B"
- Light
- ON/OFF and first speed (minimum
speed)
- Second speed (medium speed)
- Third speed (upper –medium speed )
- Fourth speed (maximum speed)
TIMER
- It activates the timer function for spe-
ed 1_2_3: keep the related key pressed for
3 seconds, aspiration will automatically turn
off after 15 minutes.
- It activates the timer function for spe-
ed 4, the timer is automatically activated .
Aspiration speed will be automatically set at
3rd speed after 7 minutes.
GREASE FILTER CLEANING AND MAINTE-
NANCE WARNING LIGHT
This function reminds you of performing cle-
aning and maintenance operations on the
hood grease filter.
This function activates after 30 hours of
operation ; it is confirmed by the flashing of
the light key when the hood is off.
The flashing is temporarily stopped when
the hood is turned on and when the lights
are turned on ; the light key will start fla-
shing again when the hood is off.
-To reset the function keep the light key
pressed for 3 seconds
N.B. The Warning function deactivation
shall be carried out when the hoods is off.
CLEAN AIR FUNCTION_ CLEAN AIR PRO-
GRAMME
This programme allows to filter the satura-
16
16
Publicité
