Atp Passcode; Radio Name Option - PERFECTPRO WORK STATION 2 Manuel De L'utilisateur

ATP PASSCODE

This radio is equipped with an Anti-Theft-Protection system (ATP system). When the
ATP system is enabled, a passcode is required for turning on the radio.
Press the On/Off button to turn on the radio.
1.
2. Press the Menu button.
3. The display shows "System".
4. Rotate the Tuning knob until the display shows "Passcode". Press the Tuning
knob. "Enable" or "Disable" will be displayed, to enable ATP, turn and press Tuning
knob to select "Enable".
5. "Change Passcode" will be displayed, enter a 4-digits numeric passcode by
pressing the preset buttons (1-10)
6. "Confirm Passcode" will be displayed. Enter a second time the same passcode to
re-confirm.
7. To disable passcode, select "Disable" as previously showed. And re-enter the
previous passcode to disable the lock.
When ATP is enabled, and if wrong passcode is entered for three times, a timer will be
activated. The next attempt will be possible only after the timer has elapsed. The timer
period will be increased with further wrong passcodes.
WARNING: If you choose to activate the passcode, please note your passcode
somewhere safe as a memory back-up in case you should forget it. This as there
is no way to reset the radio should the passcode be forgotten!
19

RADIO NAME OPTION

This radio supports customization of the radio's name. If the radio has been named,
the name of the radio will be shown when the radio is turned on and when the radio is
turned off.
1. Press the On/Off button to turn on the radio.
2. Press the Menu button, and then rotate the Tuning knob until the display shows
"System".
3. Press the Tuning knob; rotate the Tuning knob until the display shows "Name".
Press the Tuning knob.
4. Rotate the Tuning knob to select the letters. The maximum length of new name is
16 letters long.
5. Press the Tuning knob to confirm the current selection. By pressing this Tuning
knob, the cursor will be moved to next position for selection.
6. Press the P3 / or P4 / button to move the cursor to left or right.
7. Repeat step 4 to step 6 to edit the new radio name.
8. To complete editing the new radio name, you can either edit all the 16 letters or
press the Menu button.
9. When finishing editing the radio name, the LCD will display "Confirm changes"
in the first line, and display "OK" to save the changes or "Cancel" to discard the
changes.
10. To confirm the changes, rotate the Tuning knob until "OK", and then press the
Tuning knob to exit. After this action, the radio will save the new name.
11. To cancel the changes, rotate the Tuning knob until "Cancel", and then press the
Tuning knob to exit. After this action, the radio will discard the changes and keep
the current radio name as for display.
12. When next time the radio is turned on, the LCD will show "Welcome" in the first line
and the new name in the second line.
13. When the radio is turned off, the LCD will show "Goodbye" in the first line and the
new name in the second line.
Notes:
- In the name menu, when there is no operation of the panel buttons for more than 20
seconds during editing, the radio will automatically exit the name function without saving
any of the changes.
- The default radio name is empty. The new edited name will be lost and go back to
default (no name) after executing a factory reset in the menu.
- The radio supports maximum 16 letters as the name of the radio.
GB
20