Languages; Software Version; System Reset; Backlight - PERFECTPRO WORK STATION 2 Manuel De L'utilisateur

LANGUAGES

The menu of the radio can be configured to various languages.
1. Press the On/Off button to turn on the radio.
Press the Menu button, and then rotate the Tuning knob until the display shows
2.
"System".
3. Press the Tuning knob; rotate the Tuning knob until the display shows "Language".
4. Press the Tuning knob to enter the language adjustment menu.
5. Rotate the Tuning knob until the desired language appears on the display (default
is English).
6. Press the Tuning knob to confirm your choice. The display menu will change to the
chosen language.

SOFTWARE VERSION

The software display cannot be altered and is just for your reference. You can only view
the software version in DAB and FM mode.
1. Press the On/Off button to switch on the radio.
2. Press the Source button to select FM or DAB mode.
3. Press the Menu button until the display shows "Full Scan", and then rotate
the Tuning knob until the display shows "System".
4. Press the Tuning knob; rotate the Tuning knob until the display shows
"SW version".
5. Press the Tuning knob to view the software version.
6. Press the Tuning knob to back to last menu and press menu to return to
the normal radio display.
Note: USB socket inside battery compartment is for upgrading the software of the device
if needed.
17

SYSTEM RESET

If the radio fails to operate correctly, or some digits on the display are missing or
incomplete, carry out the following procedure.
1. Press the On/Off button to switch on the radio.
Press the Menu button,
2.
3. Rotate the Tuning knob until the display shows "System". Press the Tuning knob.
4. Rotate the Tuning knob until the display shows "Factory reset". Press the
Tuning knob.
5. Rotate the Tuning knob to select between "Yes" or "No". Select "Yes" if you wish
to reset the radio, otherwise, select "No".
6. Press the Tuning knob to cause the factory reset.
7. A full reset will be performed. All presets and the station list will be erased.
All settings will be set to the default values. The display will show "WELCOME
TO DIGITAL RADIO" for a few seconds, and then the radio will automatically
perform an auto scan of the Band III DAB channels and the FM band, the display
will show "Scanning" at DAB and "Auto" at FM.
In case of malfunction due to electrostatic discharge; reset the product as above to
resume normal operation. If you are not able to perform the reset operation as above,
remove and reconnect all batteries and the power supply.

BACKLIGHT

LCD backlight configuration
1. Press the On/Off button to turn on the radio.
2. Press the Menu button, and then rotate the Tuning knob until the display shows
"System".
3. Press the Tuning knob; rotate the Tuning knob until the display shows "LCD
backlight".
4. Press the Tuning knob to enter the LCD backlight adjustment menu.
Rotate the Tuning knob to select "on" in order to keep backlight always lightened
5.
when the radio is turned on with AC power supply;
6. Or rotate the Tuning knob to select "off" (by default) so that the backlight will be
lightened for about 10 seconds whenever a button is pressed with AC power
supply.
7. Press the Tuning knob to confirm your choice.
Note: The LCD backlight option "on" is only functional when the radio is powered
by AC power supply. When the radio is powered by battery power supply, the
LCD backlight is switched to option "off" – 10 seconds lightened when a button is
pressed. When the radio is connected to mains AC power again, the last user
setting will be applied again.
GB
18