Publicité
Operation
1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator to flush the water lines. Do not lose the gasket
in the aerator.
□
Ensuring the handles are in the off
position, turn on the water supply and
check for leaks. If you discover any leaks,
check your connections to ensure they
are installed properly.
□
Use the aerator wrench (not included)
to remove the aerator (F) and housing
(if applicable). Turn on the hot and cold
handles to allow the water to run for
at least one minute. This flushes away
any debris that could cause damage to
internal parts.
□
Turn off the water and reinstall the
aerator and housing (if applicable).
2
Removing the quick connector
CAUTION: Use caution when removing the quick
connecting hose connections in order to prevent cutting
your hands.
□
If it is necessary to remove the quick
connector, push the quick connecting
hose (J) up, hold the housing together
and pull down.
F
1
7
Please contact 1-855-HD-GLACIER for
2
3
J
HOMEDEPOT.COM/GLACIERBAY
further assistance.
Publicité
