12 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic power level LwA
13 PROBLEM-SOLVING
Common
Malfunction
The opeating switch is
used but the motor
does not turn
The operation switch
switch has been
activated. The motor
is very loud, can
however not pick-up
the load.
After a power loss the
brakes do not hold or
the machine slips
down
The noise of the
machine becomes
louder
The cable hoist has
too much voltage.
End-switch is not
functioning.
Copyright © 2024 VARO NV
Cause
1. It is not plugged into the power
supply.
2. The wires are broken or
ripped.
3. Switch Malfunction
4. The capacitor is burned
through.
5. End-switch has not been reset
or a micro switch error
6. The thermal switch has
suffered a wire break.
1. The voltage offered is too
small.
2. The capacitor has become
damaged.
3. The brake is not completely
open.
▪
The air between the brakes
is too large
▪
The brake spring is ripped.
▪
The brake disk is locked
▪
The brake disk is at the start
already dirty.
1. Badly oiled
2. After a long use, the cogwheel
and bearings are damaged.
3. Badly installed or dent
1. Earthed error or is not possible
2. The internal connectors are
touching the housing
1. The end-switch is defect
2. End-switch is blocked
POWX902
71 dB(A)
Solution
1. Connect the item to the
power supply.
2. Check the wires and plug
it in again to the outlet.
3. Repair switch or change it
4. Change your capacitor
5. Check the end-switch and
replace the limit switch.
6. Wait until the item cools
down, or replace the thermal
switch.
1. Adjust the work,
depending on the power
supply
2. Change power supply.
3. Allow the machine to be
repaired from a qualified
repair service
▪
1. Oil/Grease machine
officially.
2. Change the cogwheel or
bearings.
3. Check installed parts or let
a qualified person check this
1. Checked earthed wires
and properly connect them.
2. Check all internal
connections
1. Switch off or change
2. Check, repair, and change
End switch
P a g e
| 9
Allow the machine to be
repaired from a qualified
repair service.
www.varo.com
EN