Publicité
Attention! In case of direct exposure to sunlight, the temperature of the
casing will increase significantly, which will also decrease the permissible
operating time. It is therefore possible that the temperature switch will
switch off after a short time period and the cable hoist will shut down.
Please wait until the device is cooled off.
9.3
Operation
▪
Loosen the nuts
cover plate located on the
reattach the
cover
installed properly
▪
Please insert the load hook (12)
mounting
casing (3).
10 CLEANING AND MAINTENANCE
▪
Disconnect the power plug prior to performing any work on the device.
▪
Clean the device using a damp cloth and some liquid soap. Never use cleaning agents or
solvents, these could damage the device's plastic parts.
▪
Regularly inspect the total length of the steel cable (7) for damages as well as the
functionality of the limit bracket (Wind cable hoist until the stopper (10) activates the limit
bracket of the micro switch).
▪
If the steel cable (7) is damaged (split or bent, fig 6), a professional must replace it using
original replacement parts.
▪
During assembly of the cable, it is imperative to remember the stopper in order to ensure a
secure limit stop.
▪
Inspect the free movement of all mechanical components after the power plug has been
disconnected.
▪
Replace lost parts only with original parts.
▪
Return the device to your seller to ensure professional recycling.
11 TECHNICAL DATA
Rated voltage
Rated frequency
Power rating:
Rated current
Max. loading capacity
-for single cable
-for double cable
Cable speed
-for single cable
-For double cable
Hoisting height
-for single cable
-For double cable
Cable diameter
Protection rating
Motor category
Work duty
Protection rating
Weight
Copyright © 2024 VARO NV
with
double
cable (Fig 5)
of
the
3 screws
located
side.
Place the
plate
and
nuts. Please be
and
that the nuts
attached
POWX902
on
the load hook with pulley (13)
steel cable (7)
sure
that the load hook with pulley
are securely
tightened.
to the
cable
230v~
50 Hz
1050W
4.6 A
300 kg
600 kg
8m/min
4m/min
12 m
6 m
4.5 mm
IP54
A1
ED: 20%
I
18 kg
P a g e
| 8
around the deviating
into the hook bracket (5)
EN
and
remove the
shaft and
(13)
is
of
the
www.varo.com
Publicité
