Publicité
9
Assembling the Support Frame to Body of Mrs. Penguin
Insert the upper half pipe of the Support Frame (U) with a ball
plunger into the locating hole of the lower half pipe to connect the
upper and lower pipes into one body.
Insert the top hooked end at the top of the Support Frame (U) into
the connecting hole at the top of the Body of Mrs. Penguin (Q).
Insert the movable connecting rod of the Support Frame (U) into the
vertical connecting hole at the middle of the Body of Mrs. Penguin
(Q).
10
R
14
Q
U
S
T
P
Q
Assembling the Left & Right Hands and the Nose of Mrs.
Penguin
Insert the connecting rod of the Nose of Mrs. Penguin (S) into the
connecting hole of the Head of Mrs. Penguin (P).
Insert the connecting rods of the Left & Right Hands of Mrs. Penguin
(R & T) into the connecting holes at the sides of the Body of Mrs.
Penguin (Q) and fasten at two pairs of connecting loops with the Zip
Ties (V).
11
C
W
W
U
W
W
Assembling the Ground Stakes
Insert six Ground Stakes (W) over the bottom metal loops of the
Bodies of all Penguins (C & K & Q) then into the ground firmly.
Insert each two Ground Stakes (W) over the three Support Frames
of the Penguin Family then into the ground firmly.
12
Connecting the Wires
Insert all the plugs connected to the Wire Controller (Y) into all the
sockets then tighten the plastic nuts.
Q
K
W
W W
U
W
15
Publicité
