Publicité
REMOTE CONTROL BATTERIES
Press and slide the battery cover on the rear of the remote and
remove the cover. Insert 2 new AAA 1.5V batteries into the battery
compartment. Ensure that the polarity is correct. Batteries are not
included in the package due to safety during transportation.
Note: Do not mix old and new batteries together in the remote.
Do not mix alkaline, standard (carbon-zinc) or rechargeable
(Nickel-cadmium, Nickel-metal, Hydride, etc.) batteries together.
12
Note:
H
is a button with no function.
Warning: Changes or modifications to this unit not
expressly approved by the party responsible
for compliance could void the user's authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult an experienced radio/TV technician for help.
13
Publicité
