Publicité
Position the front grill (1) on the back grill (5) by hooking
it at the top with the small guard clops (17) and aligning
the bottom with the two holes (18). Close the hooks (17)
positioned around the circumference of the grill.
Assembly the unit
ASSEMBLING T HE CROSS STAND
Join the two base brackets (11).
Position the pole (13) on the two brackets
and secure with the four screws.
VENT-P40C4_MANUAL.indd 9
Insert the screws into the two holes and secure with the
nut (18).
Loosen and remove the pipe
connector (16) from lower pipe
(13). Slide plastic base orna-
ment over lower pipe onto the
base. Extend upper (inner) pipe
(14) and slide pipe connector
over upper pipe into lower pipe
and tighten.
Attach the motor with switch housing onto the upper pipe.
Ensure the switch housing is pushed fully onto the upper pipe
and secured with the screw provided (9).
15/10/20 15:13
Publicité
