Led Display Settings - Tulikivi Senso LED Mode D'emploi

LED display settings

The LED display is equipped with three buttons which you can use to adjust: LED light brightness, sound
signal volume, value of the maximum temperature of heat capacity and fuel type.
Behind the soapstone cover there are three buttons on the LED display numbered 1, 2 and 3 from left
to right. To access the settings menu, press button #3 for a couple of seconds, and the first menu will ap-
pear. The LED colour indicates the settings menu: light blue = volume, green = LED brightness, yellow = fuel
type, dark blue = the maximum temperature of heat capacity. If you want to change a setting, press but-
ton #3 and button #1 or #2 simultaneously to increase or decrease the value. To enter the following menu,
press button #3 again for a couple of seconds. You can always go back out of the menu by pressing any of
the buttons shortly, but not together with button #3.
Heat capacity lights/setup/error lights
Upper row
1.
Buttons
1. = + (->)
2. = - (<-)
3. = setup change
Notification
• One (1) beep, for four seconds (4) interval for three (3) times for »add wood«
• Two (2) beeps at two seconds (2) interval for three (3) times for »Do not add wood«
• Three (3) beeps for for four seconds (4) interval for three (3) times for »over heating«
• Two (2) beeps, for ten seconds (10) interval for three (3) times for »sensor defect«
16
Lower row
3.
2.
Info signal/setup/error light
Heat capacity, examples
Stand by
Cold fireplace
0-5 % heated
Active use
5-15 % heated
Active use
16-31 % heated
Active use
32-47 % heated
Active use