Publicité
EN
Operation
•
Connect the appliance to the mains power supply and turn on
the power switch ("I" position).
•
Set the thermostat to the desired temperature (30ºC-85ºC).
The HEAT indicator light turns on and the appliance starts to
heat up.
•
When the set temperature is reached, the HEAT indicator light
turns off. (Note: During use, the HEAT indicator light keeps on
and off, indicating the set temperature is being kept.)
•
Put the plates in. (Tip: When removing plates, it is recommend to use oven mittens to avoid burns/
scalding.)
•
After use: Set the thermostat to 'MIN' and turn off the power switch. Then disconnect from the
power supply.
Overheating protection
This appliance is featured with an overheat protection. Should the temperature exceed safe levels the
appliance will automatically cut off power.
The thermal Cut-out switch is located on the rear of the appliance. To reset the appliance after a sufficient
cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks, using a blunt pointed instrument.
3. The appliance is now reset and can be used as normal.
Cleaning, Care & Maintenance
•
Disconnect from the power supply and allow the appliance to cool before cleaning or servicing.
•
Never immerse the appliance in water, nor rinse it under running water.
•
Wipe the surface with a damp cloth.
•
Dry thoroughly after cleaning.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The unit is not
The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Appliance heats
Indicator light has expired
up but indicator
light Not On
HEAT indicator
Faulty element
light comes on
Faulty thermostat
but appliance
Thermostat set incorrectly
does not heat up
No power
Thermal cut-out switch is
activated
4
GP451-GP452_ML_A5_v1_20240920.indb 4
GP451-GP452_ML_A5_v1_20240920.indb 4
Probable Cause
Check the unit is plugged in correctly and switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Consult a qualified technician
Consult a qualified technician
Consult a qualified technician
Check thermostat
Check that the appliance is safe then press the reset
switch on the rear of the unit
Solution
2024/9/20 10:40
2024/9/20 10:40
Publicité
