Directions Before Use - VISIOMED BewellConnect MyTens Pro BW-TS1 Mode D'emploi

Tightness
Lower leg
of the calf
muscles
Training
Foot
the foot

4.4. DIRECTIONS BEFORE USE

Charging the device
Charge the device before the first use. In normal conditions (ambient temperature), it takes 5
hours to charge the device. A full charge allows a battery life of about 8 hours continuously
when functioning in normal conditions. Please charge the device fully before beginning a ses-
sion. If the charge is not complete at the beginning of a program, the battery may become
depleted before the end of the session. You cannot use the device when it is charging.
Plugging in the device figure B on page 2
1. Disconnect the cable used to connect the two connector units from the unit with the battery
light and micro-USB socket.
2. Insert the micro-USB cable into the micro-USB socket for the respective connector unit .
3. Insert the USB plug into a computer to charge the device.
4. When the battery light goes into continuous orange (which means that the battery is
being charged) to a continuous green (the battery is full), remove the micro-USB plug from
the micro-USB socket of the connector unit with the battery indicator (see diagram 4). Use the
USB plug only for the use described above (to charge and connect to the cable connecting
the two connectors units).
5. Reconnect the cable connecting the two connectors units : Insert the unit with the cable into
the micro-USB socket for the unit with the battery light .
Phase 1
Phase 2
28mn
Phase 3
Phase 4
30mn Phase 1
BewellConnect - BW-TS1 - User Manual - 122016V1
5Hz (5mn) 370
55Hz (10s) 370
6Hz (8s) 370
3Hz (10mn) 370
50Hz 200
Preparation
phase
Intensity:
50% Up:
1.5s Down:
0.75s
EMS
Intensity:
25%
Phase of
relaxation
Intensity:
40%
Up : 2s
Con : 8s
EMS
Down : 2s
Rest : 4s
17