Publicité
Assembly and dismantling
Place all the parts on the floor in front of you and check that all the listed parts are present in the specified number. Please contact the manufacturer
immediately if any parts are missing or damaged. Once assembly has been completed or started, claims due to damage or missing parts cannot be
accepted!
Make sure that the poles snap into place correctly.
1. Put the poles (3+4), the corner connectors (8) and the connectors (9) together as shown in the illustration "1".
2. Put the roof poles (1+2) and the roof connectors (10) together. Then insert it into the corner connectors (8) and the connectors (9) as shown in picture
"2".
3. Tension the roof cover (14) over the completed roof frame. Make sure that it is tightly stretched. Fasten the roof cover (14) to the roof frame with the
Velcro fasteners.
4. Insert one rod (6) into each bar (5).
5. Now carefully lift the complete roof frame with roof cover (14) with at least 2 (better 4) persons and join the corner connectors (8) and the connectors
(9) with the poles (5) as shown in figure "3".
Tip: First insert the four outer poles (5) into the corner connectors (8) and then insert the remaining poles (5) into the connectors (9).
6. Attach the ground plates (11) to the lower end of the poles (6).
7. Anchor the tent to the ground plates (11) with the pegs (12).
8. Attach the guy ropes (13) to the corners of the roof cover (14) provided for this purpose and tension them with the pegs (12).
9. Attach the side parts (15,16) to the poles with the Velcro fasteners.
When dismantling the tent, please proceed in reverse order to erecting it.
Cleaning and care instructions
Use a cotton cloth and clear water for cleaning. For stubborn dirt, we recommend lukewarm water and a mild detergent. Never use petrol, solvents,
scouring agents or chlorine-based cleaning agents. Spilled liquids should be removed immediately. Use only recommended care products for mainte-
nance.
Operating instructions
Safety information
Care instructions
8
Publicité
