Publicité
Installation Steps of R400 Gateway
1. R400 should be within 6m of the lock and there is no shielding obstruction between.
2. The gateway should face towards the door lock, as this is the optimal
direction for signal reception.
3. R400 cannot be stored in a groove of the lightweight steel or obstructed
by other metal shields.
4. Due to different materials of locks of different models, the signal reception
range is slightly different.
Indicators on R400 Gateway
1. When R400 is paired and bounded with the lock successfully and connected
properly, indicators of Service, Zigbee, WAN and Power should remain on.
2. When all indicators are ashing, it means that the lock is being unpaired.
3. Description of each indicator:
a. Service Indicator: R400 has been connected to WAFERKEY Server and
registered successfully.
b. Zigbee Indicator:
• Off: R400 is not paired with the lock yet.
• Flashing: Pairing
• Steady On: Indicates that there is more than one door lock paired.
c. Power Indicator:
• Off: R400 is not powered.
• Flashing: Indicates that R400 is communicating with the lock.
• Steady On: R400 is not powered.
d. WAN Indicator: When it is ashing, network packet is under transmission.
3
WAFERLOCK CORPORATION
Publicité
