Publicité
Risks caused by vibrations
CAUTION! Risk of injury due to vibra-
tions! Vibrations may, in particular for per-
sons with circulation problems, cause dam-
age to blood vessels and/or nerves.
If you notice any of the following symptoms,
stop working immediately and consult a doc-
tor. Numbness of body parts, loss of sense
of feeling, itching, pins and needles, pain,
changes in skin colour.
The vibration values specified in the technical data
represent the main uses of the device. The actual
existing vibrations during use may deviate from these
as a result of the following factors:
• Incorrect use of the product;
• Unsuitable tools inserted;
• Unsuitable material;
• Insufficient maintenance.
You can reduce the risks considerably by following
the tips below:
– Maintain the device in accordance with the
instructions in the operating instructions.
– Avoid working at low temperatures.
– When it is cold, make sure your body and your
hands, in particular, are kept warm.
– Take regular breaks and move your hands at the
same time to promote circulation.
Personal safety equipment
Wear goggles when working with the device.
Wear ear defenders when working with the
device.
When working with tools that cause consid-
erable dust, wear a dust protection mask.
Do not wear protective gloves when working
with the device.
Wear tight fitting clothes when working with
the device.
If you have long hair, cover or wear a hair
net.
Your machine at a glance
Note: The actual appearance of your prod-
uct may differ from the illustrations.
Dimensions
D
180 mm
d
230 mm
D
b
180 mm
D
230 mm
b
d
6 mm
22,2 mm
6 mm
22,2 mm
—
—
—
—
► P. 3, fig. 1
1. Release button for rotating handle
2. Locking button for spindle
3. Abrading disc
4. Hand grip
5. On/Off switch
6. Additional hand grip
7. Protective hood
8. Tensioning lever for protective hood
What is included
• Angle grinder
• Protective hood
• Additional hand grip
• Face pin wrench for fitting abrading disc
• Instructions for use
Fitting
Fit the additional hand grip
► P. 3, fig. 2
The additional hand grip can be fitted at the left [1],
top [2] or right [3] of the appliance.
– Screw the additional hand grip firmly into the
threaded hole on the appliance.
Rotating the handle
► P. 4, fig. 4
– The handle can be locked in three different posi-
tions. Do this by holding down the release but-
ton (1) and rotating the handle.
Permissible grinding tools
• The permissible maximum rpm or cutting speed of
the abrasive bodies used must comply with the
details in the table below.
• Therefore please observe the permissible rpm or
peripheral speed on the label of the abrasive
body.
• Always use the intermediate layers enclosed with
the abrasive bodies: they are positioned between
the abrasive body and the clamping flange and
must be at least the same size as the contact sur-
faces of the flanges.
• When using abrasive bodies with threaded
inserts, it must be ensured that the end of the
spindle never touches the perforated plate of the
grinding tool (spindle length: ► Technical data –
p. 37).
• Abrasive bodies with threaded insert must be able
to be screwed onto the grinding spindle far
enough that they firmly fit the grinding spindle
flange at the end of the grinding spindle thread.
Max. rpm
-1
8500 min
-1
6500 min
-1
8500 min
-1
6500 min
GB
max. cutting speed
80 m/s
80 m/s
80 m/s
80 m/s
35
Publicité
