Publicité
GB
Storage
If there is danger of frost, dismantle the device and
accessories, clean and store them in a place pro-
tected from frost.
NOTICE! Danger of damage to the
device! Frost will damage the device and
accessories, since they always contain
water!
Dismantle and store
1. Turn off the device, unplug the mains plug.
2. Open pressure line (turn on water spigot or noz-
zle), allow water to completely run off.
3. Completely empty the pump by unscrewing the
water drain plug (1) on the underside of the pump.
Error/Fault
Pump does not work.
Delivery rate too low.
Not enough pressure.
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
22
4. Dismantle the suction and pressure lines from the
5. Store device in a frost-free room (at least 5 °C).
Faults and remedial measures
When something isn't working...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Cause
No power supply?
Motor overheats due to high liquid
temperature?
Motor overheats due to sealed ven-
tilation slots?
Residual current protection switch
(FI-switch) activated?
Motor defective?
Water shortage?
Suction pipe not sealed?
Suction height too high?
Filter blocked or soiled?
Check valve blocked?
Water leak between motor and
pump, shaft sealing is not sealed?
Pump is blocked or defective?
Air in the pump or suction pipe?
Changed suction conditions in
spring (springs e. g. covered in
sand)?
Suction pipe sucked in on the
ground?
Disposal
Disposal of the appliance
A crossed-out wheelie bin icon means: Bat-
teries and rechargeable batteries, electrical
or electronic devices must not be disposed of
with household waste. They may contain
substances that are harmful to the environ-
ment and human health.
device.
DANGER! Risk of injury! Improperly per-
formed repairs can lead to the device not
functioning safely. This endangers yourself
and your environment.
Remedy
Check the cable, plug, and the fuse.
Eliminate cause of overheating.
(max. liquid temperature ► Techni-
cal data – p. 23)
Switch on FI-switch. If it happens
again contact the electric service
partner.
Contact your local vendor.
Ensure sufficient water supply.
Seal suction pipe, tighten screwed
connections.
Observe maximal suction height
(► Technical data – p. 23).
Suction height must be deducted
from the conveyance height.
Clean or replace filter.
Clean or replace valve.
Contact your local vendor.
Clean the pump with clean water
and remove the cause of the con-
tamination.
Fill pump case with water.
For suction pipes with check valve,
fill suction pipe with water.
Check spring and water quality.
Shorten or fasten suction pipe.
Use filter screen with check valve.
Publicité
