Publicité
Dear Customer,
You have purchased one of our top quality and dura-
ble products. Please read these instructions com-
pletely prior to installation and observe the informa-
tion contained therein.
The technical parameters are all preset so that you as
the user need not undertake any settings.
Note: 4 batteries type AA are required to put
the sensor faucet into operation. These are
not included in the scope of delivery!
Scope of delivery
► Scope of delivery – p. 3
1. 1 Fitting body
2. 2 Connecting hoses
3. 1 Battery box
4. 1 Sealing ring (metal/rubber)
5. 1 C rubber seal
6. 1 C metal washer
7. 1 Threaded bolt with fastening nut
Please check the contents of the packaging for
completeness and possible transport damage.
Technical data
Functions
Supply voltage
Sensor range
Water pressure
Switching-on time
Ambient temperature
Water temperature
Preparation for installation and
assembly
Location
The fitting and the sen-
sor display should not
be exposed to direct
sunlight or bright light-
ing.
Wash basin
It should be a wash
basin with a punched
hole diameter of more
than 28 mm.
Pipe cleaning
Flush the pipes with
water prior to installation of the fitting. Otherwise elec-
tromagnetic malfunctions in the valve may result,
impairing normal function.
Translatio n of the original instructions
Sensor faucet
DC 6V (4 AA alka-
line batteries)
10–15 cm
0,05–0,7 MPa
approx. 0.5–1 sec-
onds
1–45°C
1–80°C
Preparation for installation
Before installation, make
sure that the water supply
is switched off
Please make sure to only
screw in the connecting
hoses by hand – do not
use pliers or spanners! To
re-tighten pleas use a
size 10 open-end span-
ner!
Do not twist the hoses or
subject them to tension!
After commissioning,
check the tightness of the connections!
In case of incorrect assembly, the guarantee – par-
ticularly for consequential damage – becomes null
and void!
Assembly
1. Screw the two connecting hoses (2) with the inte-
grated seals into the fitting.
2. Screw the sealing ring (4) underneath the sensor
fitting and push it through the opening in your
wash basin.
3. Screw the threaded bolt (3) into the sensor fitting
as far as it will go and remove the fastening nut.
4. Insert the C seal (5) underneath the wash basin
and slip the C metal washer (6) onto the threaded
bolt.
5. Now screw the fastening nut onto the threaded
bolt and tighten it until the fitting is firmly fastened
to the wash basin.
6. Connect the two connecting hoses (2) with the
integrated seals at the corner valves.
7. Please connect the cable of the fitting to the cable
of the battery compartment to activate the power
supply.
8. Then you can fasten the battery box to the wall
underneath the wash basin with screws.
Please also observe the points "Before first use"
and "Method of functioning".
Inserting the batteries
Unscrew the 4 screws
of the cover. Place the
4 AA alkaline batteries
in the right direction
and screw the cover
back into place.
If the batteries need to
be changed, make sure
that they are inserted
within 5 minutes after
removing the old batteries. This prevents the original
system data from being deleted.
Please do not use batteries of a different age,
strength or manufacturer.
GB
13
Publicité
