Hubbell HBLDS30RC Mode D'emploi

REPLACEMENT COVER WITH SELECTOR SWITCH FOR
GENERAL INFORMATION
• Hubbell replacement cover Cat No. HBLDS30RC, HBLDS60RC, and HBLDS100RC series are intended
for use only with Hubbell Inc. Cat No. HBLDS30, HBLDS60, and HBLDS100 series Type 4X and Type 12
Manual Motor Controller Enclosures.
• Hubbell replacement cover with selector switch Cat No. HBLDS30RCJ, HBLDS60RCJ, and
HBLDS100RCJ series are intended for use only with Hubbell Inc. Cat No. HBLDS30, HBLDS60, and
HBLDS100 series Type 4X and Type 12 Manual Motor Controller Enclosures.
• CAUTION: RISK OF ELECTRIC SHOCK. More than one disconnect switch may be required to de-
energize this equipment before servicing. Disconnect ALL power supplies to enclosure before exposing
interior.
• NOTICE: For installation by a qualified electrician in accordance with national and local electrical codes
and the following instructions.
• NOTICE: Ensure that the rating label on replacement cover matches the rating label on the cover to be
replaced.
• This replacement enclosure cover includes a lockout provision: ON-OFF control knob (in the OFF posi-
tion) accepts up to 5/16-inch (8 mm) diameter shackle of a suitable padlock or Lockout device to isolate
energy from the connected equipment as a method of compliance to OSHA lockout/tagout regulation 29
CR Part 1910.147. This feature does NOT isolate the power supplied to the enclosure during internal ser-
vicing of the enclosure.
INSTRUCTIONS;
A. To remove the current cover, ensure the handle is in the OFF position.
B. Loosen and remove the four (4) cover screws, proceed to remove the enclosure cover.
C. Installing replacement enclosure cover: Ensure the handle is in the OFF position. Position the cover over
base to ensure alignment of cover screw holes. Tighten the four (4) cover screws to 18 lb.-in. (2.0 N m)
for HBLDS30RC and 20 lb.-in. (2.3 N m) for HBLDS60RC, HBLDS60RCJ, HBLDS100RC, and
HBLDS100RCJ series.
D. For original installation instructions of Circuit-Lock & Motor Quick Disconnect Switch, refer to PD3049 (for
30A disconnect switch) or PD3053 (for 60A &100A disconnect switch).
(replacement cover shown)
Wiring Device-Kellems
Hubbell Incorporated (Delaware)
1-800-288-6000
Shelton, CT 06484
www.hubbell-wiring.com
PD3052 (Page 1) 06/24
REPLACEMENT COVER AND
30A, 60A, & 100A
DISCONNECT SWITCH
HBLDS30RC
CIRCUIT-LOCK
HBLDS30RCJ
(replacement cover with
selector switch shown)
English