Publicité
GB
Device-specific safety instructions
• The product must be standing on an even, hori-
zontal surface with clearance to all sides.
• The product may not be operated outdoors.
• Never put objects through the protective grille into
the product.
• Objects that can be pulled (e. g. curtains, plants),
must not be in the immediate vicinity.
• Never expose the product to water or other liq-
uids.
• The product must not be operated in rooms with
bathtubs, showers or swimming pools or near to
wash basins or water connections.
• Remember that moving parts may also be located
behind ventilation and venting slots.
• If the power cord of this device is damaged, it
must be replaced by the manufacturer, its cus-
tomer service department or a similarly qualified
person, in order to avoid potential hazards.
• Symbols appearing on your device may not be
removed or covered. Signs on the device that are
no longer legible must be replaced immediately.
Read and observe the instructions for use
before using the product for the first time.
Unpacking and assembly
Unpacking
Unpacking the product and checking for complete-
ness.
Scope of delivery
• Pedestal fan
• Instructions for use
Your product at a glance
Note: The actual appearance of your
product may differ from the illustrations.
Button
Function
Press this button repeatedly to set a pe-
riod after which the fan will turn itself off
(From 1 hour – 12 hours).
Press this button to activate swing. Press
it again to cancel.
Press this button to set the natural mode
and sleep mode.
Press this button to set the 3 speeds
(High/Medium/Low).
This button can be used with any MODE.
Press this button you can turn the fan ON
and OFF.
When the fan is turned on, if it is not operated for a
long time, the LED display will turn off and automati-
cally light up when pressing any button.
The remote control uses a CR2025 battery, if the bat-
tery needs to be replaced, please follow below steps:
18
► Overview – p. 2
1. Body assembly (fan blade, front and rear grill,
motor, control panel, power cord)
2. Tube assembly (adjustable tube, stand tube, con-
nector)
3. Round base
4. Remote control
Assembly
► Assembly – p. 3
WARNING! Never operate the fan with-
out its foundation and other parts
assembled. Do operate the fan only in
upright position, any other position could
create a hazardous situation.
– Tighten the stand tube (3) to the left and fix it to
the round base (4), then connect the body assem-
bly (1) onto the adjustable tube (2), fasten them
with screw.
Operation
Check before switching on!
DANGER! Caution, risk of injury! The
product may only be put into operation if
no faults are found during the check-up.
Ensure that any defective parts are
replaced before the product is used again.
Check the safe condition of the product:
– Check whether there are any visible defects.
– Check whether all parts of the product are firmly
attached.
Using the control panel and remote control
► Operation – p. 4
This fan is equipped with 3 speeds, 3 modes, 12h
timer and remote control. For your convenience. The
buttons on the control panel of the same functions as
remote control.
Displayed
• [ ] this icon represents the NATURAL mode.
• [ ] this icon represents the SLEEP mode.
• When [ ] and [ ] lights are OFF, the fan is in
NORMAL mode.
► P. 4, fig. 2
– Open the batter cover at the bottom of the remote
control, press the buckle on the battery cover
inward and pull it out, take out the old battery.
Publicité
