Publicité
Figure 1,
Place the largest log diagonally
centered on the burner.
Place the curved log near the protective
screen for air flow.
Pour the tumbled lava stone into the Outdoor Fire Pit so that the burner
Figure 1.
Pour the first bag of the
tumbled lava stones
media into the burner
support.
CAUTION:
YOU MUST MAINTAIN THE LAYOUT AS SHOWN TO ENSURE PROPER OPERATION OF YOUR FIRE PIT.
IF YOU NEED TO REPOSITION ANY MATERIAL TO MAINTAIN THE PROPER LAYOUT, USE HEAT
RESISTANT GLOVES OR ALLOW MATERIAL ADEQUATE TIME TO COOL BEFORE HANDLING.
CAUTION:
Lava granules used in a fire pit are porous and when heated up to normal operating temperature
can cause trapped gasses or moisture to expand and cause a "pop" and "launch" outside of the fire pit, which
could cause injury or property damage. Allow lava granules to completely dry after getting wet
CERAMIC LOG MEDIA PLACEMENT
Please the larger two logs as
desired using the largest log as the
Note: See Page 7 for Protective Screen Media Clearance
TUMBLED LAVA STONE PLACEMENT
is covered by 1/2" and spread evenly.
NOTE: See Page 7 For Protective Screen Media Clearance
(See Figure 1 and 2)
BURN HAZARD. LAVA GRANULES, CERAMIC LOGS and TUMBLED LAVA STONE
WILL REMAIN HOT FOR SOME TIME AFTER USE.
hosed off, before lighting and using the fire pit.
Figure 2,
support.
Figure 2.
Pour the additional bag of
tumblked lava stones onto
the burner support. Spread
the media evenly covering
the burner.
Protective Screen
Page 9
Figure 3,
Place the balance of the logs as desired.
Make sure to leave
enough space for proper air flow.
,
rained on or
Publicité
