BH FITNESS YF35 Instructions De Montage Et Utilisation page 16

BELT OFFSET TO THE RIGHT
This procedure is very important. Follow these
steps. In order to adjust the belt, set the unit in
motion at a speed of 4 km/h. If the belt has
moved to the right, turn screw (R) on the right-
hand side of the machine a 1⁄4 turn clockwise.
Note the position of the belt, if after one minute
the belt is not completely centred then repeat
the operation. If you see that the belt has moved
too far over to the left then turn the right screw
back slightly in an anticlockwise direction. Figure
11.
As soon as you have adjusted the belt you can
begin exercising again.
BELT OFFSET TO THE LEFT
In the event that the belt has moved to the left,
turn screw (L) on the left-hand side of the
machine a 1⁄4 turn clockwise. Note the position
of the belt, if after one minute the belt is not
completely centred then repeat the operation. If
you see that the belt has moved too far over to the
right then turn the left screw back slightly in an
anticlockwise direction. Figure 11. Important:
Overtightening of the belt can lead to a loss of
speed on the machine and even stretch the belt
itself. Bear In mind that one turn of the right
screw (R) in a clockwise direction has the same
effect on the position of the belt as one turn of
the left screw (L) in an anticlockwise direction.
Consequently, in the event of excessive belt
movement you can use either of the two screws
in order to avoid overtightening the belt
OPERATING INSTRUCTIONS
Plug the machine into the mains supply. Set the
ON/OFF button at the back of the machine to
the ON position, the LED will light up indicating
that the machine is switched on. A beep will
sound and the monitor will come on.
SAFETY KEY
The machine will only operate if the safety key
(k) is inserted into the monitor. In case of
emergency release the safety key (k).
switch the machine on again, set the ON/OFF
button to the OFF position and then reinsert the
safety key (k) into the monitor unit.
MONITOR
Technical specifications
Time: 00:00 – 99:00 min
Speed: 1.0 – 10 km/h
Distance: 1.0 – 99.0 km
Calories: 10 – 9990 Cal
Operating the monitor:
START/STOP
- Press the START/STOP button to start
the exercise.
- Press the
interrupt the exercise.
- Press the
continue the exercise.
16
START/STOP button
START/STOP button
To
to
to