Publicité
EN Installation Manual
Connect the mirror's connecting cable to the socket or cut the plug and connect the mirror's connecting cable to the mains cable or electrical box.
You can use a connection terminal block with IP protection for bathroom equipment to connect the cables. Make sure there is no electricity in the
supply cable before starting the connection!!! Connect the power cable of the luminaire to the power supply on conductors L and N. The terminal
block is not included in the product. Use only the recommended supply voltage 230 V AC, 50 Hz, L and N with pre-set fuse of max. 16 A.
Use
The sensor has memory. When the mirror is switched off and then switched on, the last set colour and light intensity is used.
4
> 0,5 sec - temeperature (K)
< 0,5 sec - intensity
warm
day
cold
�
�
light
light
light
3000 K
4000 K
6000 K
<10%
100%
Publicité
