Publicité
Technical Specifications
Power supply
Pre-wired protection
Input
Electrical class
Light source
Light source service life
Ballast
Protection
The light source of this luminaire is non-replaceable, the whole luminaire must be replaced at the end of its service life!
Electric Diagram
Products: ZPRKU80LED
L
N
Assembly Instructions
The luminaire can be installed in the washbasin area and in areas with a bathtub or shower outside the 0+1+2 zone (see pictures in the Assembly
Instructions). The electrical installation must be carried out by a person with an electrical qualification. The connection is carried out by: a) moving
supply b) connecting the supply cable (at the back of the mirror) to the existing wiring in the wiring box preferably located behind the mirror. If there
is already a connection cable on the wall, it can be connected via the terminal box to the connection cable on the back of the mirror.
For assembly use a dowel and a screw (not included).
First, prepare the mirror location. The easiest way to select the correct position of the mirror is to directly place the mirror in the desired location on
the wall and check if the position suits you.
230 V AC 50 Hz, L+N
10 A max RCD (Fi) 30 mA.
5-50 Watt
I.
LED strip, warm light / daylight / cold light
up to 50 k hours
1–2 x electronic ballast for 12 V DC SELF
IP 44
-
supply
Zdroj
5-50W
230V
12V
+
SELV
Install outside the 0+1+2 zone
Zone
Zone
Zone
Bathtub side view
LED
EN Installation Manual
3
Publicité
