Publicité
Checking the battery charge
condition
NOTE: Fig. D3 only applies for the
battery pack with battery indicator
light.
Charging the battery pack
NOTE:
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More
details can be found in charger's
manual.
Battery power indicator on the
machine
See details in BATTERY STATUS
section
Operation
To start
WARNING! The cutting head
continues to rotate after
the trimmer has been switched
off; wait until it has completely
stopped then lay down the tool.
Press the lock-off button first, then
press the switch trigger to start the
machine.
ECO Speed
For longer run time, press the ECO
button and switch trigger, then
your machine will operate at a low
speed.
Trimming
Bump feed
Assembling and removing the
trimmer head
Insert the hex key into the hole
and rotate the trimmer head
until it stops in a locked position.
Then, rotate counterclockwise
to remove it, and clockwise to
assemble it.
Winding the trimmer line
NOTE: The spool must be wound
while installed in the trimmer
head. Externally refilled spools
inevitably leads to problems.
BATTERY STATUS (See Fig. D5)
Before starting or after use, press the button beside
the power indicator light on the machine to check
Cordless Grass Trimmer
the battery capacity. During operation, the battery
capacity will be indicated automatically by the battery
power indicator.
See Fig. D3
The indicator constantly senses and displays the
battery condition as follows.
For the machine with 2 battery packs with different
power, the power indicator light displays the battery
condition with the lower one of the two batteries.
Battery power
indicator status
See Fig. D4
Five green lights
(
illuminated.
Two, three or four
green lights are
See Fig. D5
illuminated.
Only one green light
(
illuminated.
No light is
illuminated.
See Fig. E
Only one light is
flashing twice per
cycle.
Only one light is
flashing three times
See Fig. F
per cycle.
Only one light is
flashing four times
See Fig. G
per cycle.
See Fig. H
OPERATION INSTRUCTIONS
attempt to use any other devices. Never insert or allow
See Fig. I
metallic objects into your charger or battery pack
connections because of an electrical failure and
hazard will occur.
1. Bump-line feed system (See Fig. H)
The trimmer is equipped with a bump-line system. Just
bump the trimmer head while the machine is running,
See Fig. J1,J2
new line will feed out.
2. Winding the trimmer line (WA0201)(See Fig.
J1,J2)
Insert the replacement line through the eyelet and
feed it through the other side. Ensure both ends of
the line are even on each end of the trimmer head
Battery condition
The two batteries are in a highly
) are
charged condition.
The two batteries have a
remaining charge. The more lights
are illuminated, the more battery
capacity.
At least one battery is almost
) is
depleted and needs to be
charged.
At least one battery is not fully
installed or battery may be
defective.
At least one battery is over
discharged (please refer to the
battery charge condition), please
recharge the two batteries at
once before use again or storage.
At least one battery is hot, wait
for them cool down before start
again.
The machine is over load. Raise
the cutting height or push slowly.
WARNING! The charger and battery pack are
specially designed to work together so do not
13
EN
Publicité
