Publicité
CONNECTION
-
Connect the loudspeakers to the required loudspeaker output depending on your installation. Do not use
more than one type of output at the same time.
-
The loudspeakers must be connected in a series/parallel circuit so that the load impedance of the
loudspeakers is the same as the load impedance of the amplifier output and that the power supplied by
the amplifier does not exceed that withstood by the loudspeakers.
-
Once the connections have been made according to your needs, connect the devices to the power
supply and switch them on. After use, do not forget to switch off and disconnect the device from the
power supply.
Three operating modes can be selected using the selector located on the rear part of the device: parallel
mode (PAR), stereo mode (STE) or bridge mode (BRI).
PARALLEL MODE
Place the selector located on the rear part of the power amplifier in the PAR position.
In this mode, the input of the two channels will be the channel A input signal. Connect the CH A input and
the two loudspeaker outputs. The volume is adjusted separately.
CH B
GND
LIFT
CH A
INPUTS
STE
BRI
PAR
CH B
CH A
(1+, 1-)
BRIDGE
8
ONLY
-
+
+
MODE
STE
BRI
PAR
OUTPUTS
(1+, 1-)
STEREO/
SA-204
PARALLEL
STEREO POWER AMPLIFIER
150 + 150 W RMS, 4
100 + 100 W RMS, 8
-
200 W RMS BRIDGE 8
(1+, 2-)
BRIDGE - 8
ONLY
- 3 -
~115 V AC, 50/60 Hz FUSE: 6.3 A
~230 V AC. 50/60 Hz FUSE: 3.15 A
AC SELECT
POWER CONSUMPTION: 700 W
150 + 150 W RMS@4
100 + 100 W RMS@8
EN
Publicité
