Publicité
SETTING THE STOP COLLAR
Always be sure to set your stop collar to the
top line of the drill extension and secure the
set screw with the 1/8" Hex Key provided.
Setting the stop collar to this line, ensures
maximum depth of your cut.
**
Be sure to check your endmill and set
make sure you do not cut t o deep or not enough
ADJUSTING THE DEPTH STOP
The Pocket Mill Pro plunges into your material up to 0.8267 or 21mm however
if you do not want to go that deep, you can lower the built in depth stop by
turning the brass dial
Original Position
**
Make sure you return it back to the starting position after your project and
before you begin your next project to avoid a depth issue
End Mill Size
5 MM
6 MM
8 MM
10 MM
1/4"
3/8"
. Each revolution is 1mm or 0.039 inches.
7
Cut Depth in Inches
0.668"
0.825"
1.061"
1.061"
.750"
1.00"
before beginning another project to
Depth Stop Lowered
Cut Depth in MM
17 mm
21 mm
27 mm
27 mm
19.05 mm
25.4 mm
Publicité
