Télécharger Imprimer la page

JessEm POCKET MILL PRO 08250 Mode D'emploi page 4

Publicité

Take (1) Clamping Block
(1) 1/4" Stainless Washer
and (1) Small Adjustable knob
and
Clamping Bolt. Repeat this step for the
opposite side.
To mount the Pocket Mill Pro to the
angle, loosen the two mall
angle and line up each
on either side of the
mounting plate. Slide the Pocket Mill
Pro onto the slots on the angle shown
in Figure 2. Tighten down the locking
handles.
** These handles are adjustable
locking knobs. To reset or adjust, lift
the handle up and rotate it until they
lock into place.
.
Start by putting the (2) 1/4"
washers
handle
Stainless Steel S
.(See Figure 3.)
over the
on either side of the
block
your
followed by the
and (2)
ON THE ANGLE
,
4

Publicité

loading