Maintenance And Cleaning - Nicols BIRDY BEAM/3 Notice D'utilisation

8 Prism
9 Reset
5.TROUBLESHOOTING
Following are a few common problems that may occur during operation. Here are some suggestions for easy troubleshooting:
A. The fixture does not work, no light
a) Check the connexion of power and main fuse.
b) Measure the mains voltage on the main connector.
B. Not responding to DMX controller
a) DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
b) If the DMX LED is on and no response to the channel, check the address settings and DMX polarity.
c) If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the fixture or the previous one.
d) Try to use another DMX controller.
e) Check if the DMX cables run near or run alongside to high voltage cables that may cause damage or interference to DMX
interface circuit.
C. Some fixtures don't respond to the easy controller
a) You may have a break in the DMX cabling.
b) Check the LED for the response of the master/ slave mode signal.
D. No response to the sound
a) Make sure the fixture does not receive DMX signal.
b) Check microphone to see if it is good by tapping the microphone.
E. One of the channels is not working well
a) The stepper motor might be damaged or the cable connected to the PCB is broken.
b) The motor's drive IC on the PCB might be out of condition.

6. MAINTENANCE AND CLEANING

1.
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. Cleaning frequency
depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on
the unit's optics.
 Clean with soft cloth and use normal glass to clean fluid.
 Always dry the parts carefully.
 Clean the external optics at least every 20 days. Clean the internal optics at least every 30/60 days.
 In order to keep the gobo wheel rotation and smooth movement, it is suggested to add a good quality grease about every 60 days
Backwards gobo rotation from
200-255 slow to fast
0-9 OFF
10-63 ON
Forwards rotation from fast to
64-159 slow
Backwards rotation from fast to
160-255 slow
200-219 Reset