Publicité
Assembly - Attaching the Light Kit
7
Attaching the light kit
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light kit.
□
Remove the three screws (QQ) from the switch cup cover of
the light kit fitter assembly (E).
□
Connect the wires exiting the bottom of the motor assembly
(D) by connecting the molded adaptor plugs (SS) together
(blue to blue, white to white).
□
Slide the switch cup light kit (E) and secure it to the switch
housing using the three screws (QQ) that were removed in
the first step.
8
Installing the bulbs and attaching the
glass bowl
CAUTION: Make sure the power is off before attaching or
removing the glass bowl.
CAUTION: Over lamping the fan will result in the fan lights
shutting down until the proper wattage bulbs are installed.
Reset the lights by turning off the power, replacing the bulbs
with the correct wattage bulbs, and turn the power on.
WARNING: Allow the glass bowl to cool completely before
removing.
□
Remove the finial (UU) and glass holder (TT) from the light
kit fitter assembly (E).
□
With power off, install the two bulbs (not included) by
twisting them into the light bulb sockets. Position the glass
bowl (H) over the threaded nipple and pass the pull chain
for the fan through the hole under the glass bowl (H).
□
Re-install the glass holder (TT) and finial (UU).
□
Attach the pull chain extensions (FF).
QQ
H
TT
UU
FF
11
Please contact 1-855-HD-HAMPTON for further assistance.
D
SS
E
HOMEDEPOT.CA
Publicité
