Publicité
Stand and Base Assembly
1. Align holes on the coupler of the outer stand with holes on the fan base.
2. Insert screws with nuts from the accessories bag and tighten securely.
Stand Assembly
1. Remove the two screws from the extension rod adjuster.
2. Insert the extension pipe into the outer stand rod.
3. Align the two holes on the outer stand rod with the holes on the adjuster and secure
the adjuster with two the screws removed in step 1.
4. Adjust the extension rod to desired height.
5. Tighten the L-shaped screw to set the height.
Stand and Motor Assembly
1. Remove the bolts, flat washers and nuts from the extension rod.
2. Align the upper round hole on the extension rod with the round hole on the motor
bracket.
3. Insert the bolt and replace the flat washer and nut which are removed from step 1.
4. Adjust the fan head to the desired tilting angle and insert the bolt through the lower
square hole on the extension rod assembly with the cambered slot on the motor
bracket, then secured with flat washer, lock washer and nut which are moved from
step 1.
5. Tighten the bolts and nuts.
6. Repeat step 3-5 to adjust the airflow upward or downward.
Rear Guards and Blades Assembly
1. Remove the four screws, spring washers and the flat washer from the motor around
the motor shaft.
2. Align the rear guard over the threaded holes on the motor. Ensure the small hole on
the rear guard is located downward.
3. Secure the rear fan guard and the motor with the screws removed in step 1.
4. Remove the screw on the blades' circular slot and carefully slide the blade assembly
over the shaft. Tighten the screw to fix the blades on the groove on the shaft.
CAUTION : Do not alter angle of blades or bend them in any manner.
Front Guards Assembly
1. Open the clips on the front of the guard.
2. Hang the front guard on the top rib of the rear guard by utilizing the U-shaped fixed
clip on the top of the front guard.
3. Insert and secure the safety guard bolt, spring washer and nut.
4. Press the clip down around the front guard to secure.
ASSEMBLY
-4-
Publicité
