Publicité
Before igniting the burner, ensure that the system is filled with water and
that all controller settings are at their proper values and that it is operating
correctly. Start the stove by setting the temperature setting you need from
the control panel.
Wait for the burner to rise above the system temperature by 80 ° C, then
re-vent the air in the installation. After the first heating of the system, the
air which is dissolved in the water will be released again, it has to be
Again, check that all safety elements work properly and are set correctly
to meet the system requirements of the other equipment.
The product is started by holding down the On/Off button on the panel
and it is stopped by pressing the same button again. By pressing the
Set button, the stove temperature is adjusted and at the same time,
weekly programming is possible. It is not advisable for the user to
change other parameters in the panel.
It is recommended to install a room thermostat and thermostatic
valve to the radiators from one of the places to be heated. These
devices will meet the same fuel economy and comfort.
The product's maximum temperature setting is 80 ° C, minimum 65 ° C,
Check the maximum operating pressure of the boiler. The return water
temperature should not be below 55 ° C.
The water pressure should be checked at certain intervals from the
backside manometer and should be increased to 2 bar by the addition
of water when it falls below 1 bar.
evacuated.
Publicité
