Publicité
RDH-130/ 150/ 170
2. Continuous draining
Water can be automatically emptied into a floor drain by attaching the unit with a water hose (Ø 24mm/1 inch of diameter, not included Fig.9)
•∙Remove∙the∙water∙bucket∙from∙the∙unit∙and∙set∙aside.
•∙Lift∙up∙the∙side∙flap∙located∙on∙the∙right∙side∙of∙the∙unit∙as∙looking∙from∙the∙front∙(Fig.10)∙
•∙Insert∙the∙female∙threaded∙end∙of∙the∙water∙hose∙through∙the∙opening.∙(Fig.10a)∙
•∙Screw∙the∙gardening∙hose∙onto∙the∙threaded∙portion∙of∙the∙tray∙underneath∙the∙bucket∙opening∙(Fig.∙10b)∙
•∙Make∙sure∙the∙hose∙is∙securely∙connected∙to∙the∙unit∙so∙there∙are∙no∙leaks.
•∙Direct∙the∙hose∙toward∙the∙drain,∙make∙sure∙that∙there∙are∙no∙kinks∙that∙will∙stop∙the∙water∙flowing.
•∙Place∙the∙end∙of∙the∙hose∙into∙the∙drain.
•∙Place∙the∙bucket∙back∙in∙the∙unit∙and∙make∙sure∙that∙it∙is∙located∙correctly.∙(Fig.∙10c)∙
•∙Select∙the∙desired∙humidity∙setting∙and∙fan∙speed∙on∙the∙unit∙for∙continuous∙draining∙to∙start.
nOTe: If the unit stops operating, check that the bucket Full light is illuminated. If it is, remove the bucket and empty the water and then check the seal between the hose and the
unit. If there is a small leak then replace the hose gasket and re-tignten the hose.
Fig.9
Fig.10
Fig.10a
Fig.10b
Fig.10c
11
Publicité
